10
Master Volume Feature
Master Volume Feature
The Master Volume Feature allows you to select a
single device (TV, cable box or audio receiver) that
the volume control always controls. For example, the
remote can be in TV mode while the volume buttons
control the volume on your cable box instead
of your TV.
Enabling the Master Volume Feature
1. Press and hold the
SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release desired device
button (
TV, DVD, CBL) for the device
you wish to control the volume.
3. Press and release the
MUTE button.
4. Press and release the
VOL + button.
The red indicator will blink twice and
then go off.
To test the feature put the remote in
another mode such as the TV mode if
you programmed the cable box to be the
Master Volume Device. Point the remote
at the cable box, press and hold either
the
VOL + or the VOL - button. If the cable
box volume changes then the remote is
programmed correctly. If the TV volume
changes and not the cable box, you will
have to repeat the steps above and test
again.
Disabling the Master Volume Feature
1. Press and hold the
SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the device button
(
TV, DVD, CBL) which is programmed
to control the Master Volume Feature.
