17
5. The remote displays
SELECT THE KEY TO LEARN TO
. All keys
except
SET
,
Z-Wave
,
OK
, or
Arrows
(scroll left & scroll right)
are available for learning. Press the key you want to teach the
command to.
6. The remote displays
WHEN BACKLIGHT TURNS OFF PUSH
TEACHING KEY
. The backlight turns off. The display reads
LEARNING NOW! PRESS TEACHING KEY
. Press the teaching
key on the original remote control.
7. If Learning is successful, then display and backlight turn back
on. The remote displays
SUCCESS! PUSH OK TO LEARN PUSH
SET TO EXIT
.
8. Press
OK
to learn another key or press
SET
to exit Learning
mode. If you press
OK
, the remote returns to step 5 above and
is ready to learn another key.
NOTE: If learning fails, the display reads LEARNING FAILED PUSH
OK TO LEARN PUSH SET TO EXIT.
Possible causes for learning failure:
• Your remotes are too close to a UV source (i.e. in sun light,
or close to fluorescent lighting)
• Your remotes are too far apart.
• The teaching remote is an RF (radio frequency) remote.
Teaching remotes must be IR (infrared).
• The remotes’ IR LEDs are not aligned.
• Batteries in one or both remotes may not have a sufficient
charge
Deleting All Learned Keys
To delete all learned keys for a selected device, perform the
steps below:
1. From
ADD LEARN KEY
use the
ARROW
keys to scroll to
DELETE
LEARN KEY
. Press
OK
.
2. The remote displays
SELECT MODE THEN PUSH OK
. The
device name is displayed on the bottom line of the display
(for example, TV). Use the
ARROW
keys to cycle through the
available device types. Press
OK
.
3. The remote displays
SELECT KEY TO DELETE OR PUSH OK TO
DELETE ALL.
4. Press
OK
. The remote displays
DELETING ALL PUSH OK TO
CONFIRM
.
5. Press
OK
. The remote displays
ALL LEARNED KEYS DELETED.
PUSH OK TO DELETE MORE
.
6. Press
SET
to exit
