8
NOTE: If an invalid code is entered, the LED emits one long blink,
and the LCD displays INVALID.
5. The selected device turns off if the code was successful. You
can also try pressing additional keys on the remote to test
other functions.
6. If the code you entered functions properly for all keys tested,
Press OK to save the code.
7. If the code you entered does not function properly, Press
SET
one time and repeat steps 2-6, trying the next available code
from the manufacturer’s code list.
8. If none of the codes listed for your brand/type of device
function properly, you can try searching for its code (next
section) or use the “Learn Function” as described on page 16.
Adding a Device by Searching for Its Code
1. Press and hold
SET
until the remote displays
INITIAL SETUP
.
Press
OK
.
2. The remote displays
ADD DEVICE
. Press
OK
3. The bottom line of the display lists
RECEIVER
as the first device
you can add. Press
OK
or use the
ARROW
keys to scroll left or
right, select a different device to add and then press
OK
.
4. The remote displays the device name on the top line and Code
Setup on the next line.
5. Use the
ARROW
keys to slowly scroll through the
manufacturer’s codes for your device type (i.e., Receiver).
When you have selected the correct code, the device will turn
off. If you accidentally scroll past the correct code, you can use
the other arrow key to go back.
6. Press
OK
to save the code.
7. If none of the codes work for your device, you are offered the
option of using the “Learn Function” (see the instructions for
learning in the “Advanced Functions” section of this manual).
Press
OK
to learn or
SET
to go back one level in the menu.
NOTE: If you cannot find the working code or brand for your
receiver, try the codes for Amplifier, and then Misc. Audio.
Scroll left or right to search for the device when the remote
displays ADD DEVICE.