Connecting EnerVista 750/760 Setup to the Relay
750/760 Quick Reference Guide
13
Figure 13: Communications using rear Ethernet port
CONNECTING ENERVISTA 750/760 SETUP TO THE RELAY
Configuring Serial Communications
Before starting, verify that the serial cable is properly connected to either the RS232 port on
the front panel of the device (for RS232 communications) or to the RS485 terminals on the
back of the device (for RS485 communications). See
on page 11 for connection
details.
This example demonstrates an RS232 connection. For RS485 communications, the GE
Multilin F485 converter will be required. Refer to the F485 manual for additional details. To
configure the relay for Ethernet communications, see
Configuring Ethernet communications
Install and start the latest version of the EnerVista 750/760 Setup software (available
from the GE EnerVista CD). See the previous section for the installation procedure.
2.
Click on the
Device Setup
button to open the Device Setup window and click the
Add
Site
button to define a new site.
3.
Enter the desired site name in the
Site Name
field. If desired, a short description of site
can also be entered along with the display order of devices defined for the site. In this
example, we will use “Substation 1” as the site name. Click the
OK
button when
complete.
4.
The new site will appear in the upper-left list in the EnerVista 750/760 Setup window.
5.
Click the Add Device button to define the new device.
6.
Enter the desired name in the
Device Name
field and a description (optional) of the
site.
996711A1.CDR
Summary of Contents for 750
