background image

Electrical 

 

 Read Carefully.

How to connect

230/208-volt perpendicular,

electricity

tandem or large tandem type wall
outlet. These 

 of outlets are

For personal safety,
this appliance must be
properly grounded.

Electrical requirements

 models require a 

volt a.c., 60   grounded outlet
protected with a 15 amp time delay
fuse or circuit breaker.

The power cord on these 

 has

a three-prong (grounding) plug that
mates with a standard three-prong
(grounding) wall outlet (Fig. 1) to
minimize the possibility of electric
shock hazard from these appliances.

PREFERRED
METHOD

T

 

 

.

\

INSURE PROPER

 EXISTS

Fig. 1 ‘

BEFORE USE

Where a standard two-prong wall
outlet is encountered, it is  your

 

available at most hardware stores.

230/208-VOLT

MATCHING

PERPENDICULAR TYPE WALL OUTLET

LINE CORD PLUG

REQUIRES 20 AMP TIME DELAY FUSE

OR CIRCUIT BREAKER 

230/208-VOLT

MATCHING

 TYPE

WALL OUTLET

LINE CORD PLUG

REQUIRES 15 AMP TIME DELAY FUSE

OR CIRCUIT BREAKER PROTECTION

60

\,

230/208-VOLT

MATCHING

LARGE TANDEM TYPE WALL OUTLET

LINE 

 PLUG

REQUIRES 30 AMP TIME DELAY FUSE

OR CIRCUIT BREAKER PROTECTION

TEMPORARY METHOD

I

 

(ADAPTER PLUGS NOT

P

ON

Fig. 2

BEFORE USE

The 

 slot in the 

 must be

aligned-with the larger 

 in the wall

outlet to provide proper polarity in
the connection of the power cord.

CAUTION: Attaching the adapter
ground terminal to 

 outlet cover

screw does not ground the appliance

 cover screw is metal, and not

insulated, and wall outlet is grounded

through house wiring. You should
have the circuit checked by a 
electrician to make sure the outlet

is properly grounded.

When disconnecting the power cord
from the adapter, 
always hold the
adapter with one hand. If this is not

done, the adapter ground terminal is
very likely to break with 

 use.

Should the adapter ground
terminal break, DO 

 USE the

appliance until a proper ground
has again been established.

personal responsibility and 
to have it replaced with a properly

Whether your air conditioner is a

grounded three-prong wall outlet.

115-volt or a 230/208-volt unit, it

Use of 

 cords

is 

 to have the 

DO 

 UNDER ANY

CIRCUMSTANCES, CUT
OR 

 THE THIRD

(GROUND) PRONG 

THE POWER CORD.

230/208-volt 

 require their

own single branch circuit supplying
230/208-volt a.c., protected with a
time 

 fuse or circuit breaker.

This is recommended for best
performance and to prevent
overloading house wiring circuits,
which could cause a possible fire
hazard from overheating wires.

 power cord on these models

has a 230/208-volt perpendicular,
tandem or large tandem type plug
that mates respectively with a

outlet and circuit checked by a
qualified electrician if there is
any doubt as to whether a proper
ground 

Use of adapter plug

 

 only)

Because of potential safety hazards
under certain conditions, we

strongly recommend against use
of an adapter plug. 
However,
if you still elect to use an adapter,
where local codes permit, a
TEMPORARY 
may be made to a properly grounded
two-prong 

 outlet by use of a

 listed adapter (Fig. 2) available

at most local hardware stores.

Because of potential safety
hazards under certain conditions,
we strongly recommend against the
use of an extension cord. 
However,
if you 

 

 to use an extension

cord, it is absolutely necessary that
it be a 

 listed 3-wire grounding

type appliance extension cord and
that the current carrying rating of
the cord in amperes be equal to or
greater than the branch circuit size
shown on the rating nameplate of

the appliance.

Summary of Contents for ACD09L









Reviews: