Problem
Possible Causes
What To Do
Air conditioner
The air conditioner
•
Make sure the air conditioner plug is pushed completely
does not start
is unplugged.
into the outlet.
The fuse is blown/circuit
•
Check the house fuse/circuit breaker box and replace
breaker is tripped.
the fuse or reset the breaker.
Power failure.
•
If power failure occurs, turn the air conditioner
OFF
.
When power is restored, wait 3 minutes to restart the
air conditioner to prevent tripping of the compressor
overload.
Air conditioner does not
Airflow is restricted.
•
Make sure there are no curtains, blinds or furniture
cool as it should
blocking the front of the air conditioner.
The temp control may not
•
In
COOL
mode, press the
Decrease
▼
pad.
be set correctly.
The air filter is dirty.
•
Clean the filter at least every 30 days.
See the
Operating Instructions
section.
The room may have been hot.
•
When the air conditioner is first turned on, you need to
allow time for the room to cool down.
Cold air is escaping.
•
Check for open furnace floor registers and cold air
returns.
Cooling coils have iced up.
•
See
“Air conditioner freezing up”
below.
Air conditioner
Ice blocks the air flow and
•
Set the controls at
HIGH FAN
or
HIGH COOL
and set the
freezing up
stops the air conditioner
thermostat to a higher temperature.
from cooling the room.
Water drips outside
Hot and humid weather.
•
This is normal.
Water drips indoors
The air conditioner is not
•
For proper water disposal, make sure the air conditioner
tilted to the outside.
slants slightly from the case front to the rear.
Water collects in
Moisture removed from air
•
This is normal for a short period in areas with little
base pan
and drains into base pan.
humidity; normal for a longer period in very humid
areas.
The remote control
The batteries are inserted
•
Check the position of the batteries. They should be
is not working
incorrectly.
inserted in the opposite (+) and (–) direction.
The batteries may be dead.
•
Replace the batteries.
“E1” appears in
Function error code.
•
Unplug the air conditioner. Wait 3 minutes and plug it
the display
back in. If the error code reappears, call for service.
Before you call for service…
www.GEAppliances.com
Troubleshooting Tips.
Save time and money! Review the chart below first and
you may not need to call for service.
15
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
