DRAINA E INSTRUCTION
It has two drainage methods that can be used:
manual drainage and continuous drainage.
1.When water tank is full, water-full indicator is on, the
unit will stop working, and buzzer will sound till water
is pour off.
2.The water tank is located on the back side of your
device. Hold the water tank with both your hands and
pull it out carefully.Empty the water tank.
3.Replace the water tank, dehumidifier restarts working.
1.Cut the small plastic round cover that is located on the
back side of your device as shown in below photo.
2.Remove the water tank and then connect a water pipe
in the back, (inner diameter is 9mm) water can be drained
continuously.
3.Horizontally align the pipe and then reinstall the water
tank to its place in the unit carefully so that the unit may
be able to start working again.
1. Water pipe cannot be too long (usually 0.6m), the height
cannot surpass the height of drainage mouth, or there will
be water leakage.
2. When your device is running with the continuous
drainage pipe connected, you may select the Continuous
mode to run permanently on your device.
3. Please ensure that the hose is directed downwards,
allowing water to flow by gravity to an external drain.
4. Ensure that the end of the hose is lower than the drain
opening, otherwise the water will not drain and flooding
may occur.
1. Make sure that the water tank is correctly repositioned
inside the unit. In the opposite case, a warning buzzer
sound will be heard, the unit will not be working and the
full water tank indicator light will remain illuminated.
2. You must also be very careful so that you may not pull
or move the floater of your unit whilst removing the water
tank as this would affect the magnetic control switch and
the unit will not be able to operate properly.
3. Your dehumidifier should resume its operation 3 minutes
after the water tank is reinstalled in its place. This delay
provides protection to your compressor.
MANUA DRAIN
NOTE:
DRAIN
NOTE:
ENGLISH
7
CONTINUOUS
