Install the Window Locking Bracket and the Foam Top Window Gasket
Attach the window locking bracket with a
type C screw.
Cut the foam top window gasket to the
window width.
Stuff the foam between the glass and the
window to prevent air and insects from getting
into the room.
C
B
A
6
Install the Air Conditioner in the Case
Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on
each side of the case.
Before installing the front grille, pull out the
vent control lever located above the unit
control knobs, as shown.
Attach the front grille to the case by inserting the
tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.
Lift the inlet grille and secure the front frame
with a type A screw through the front grille.
Lower the inlet grille back into place.
D
C
B
A
7
Guide the lever carefully
through the grille as you
push it in.
Window Installation Instructions.
14
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions