5
ge.com
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
TI
Use the
COOL
mode with
HIGH (F3), MED (F2)
or
LOW (F1)
fan for cooling. Use the
Increase
▲
/
Decrease
▼
pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on and
off to keep the room at the set level of comfort. Set
the thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned
on while set to a
COOL
setting or if turned from a fan
setting to a
COOL
setting, it will take approximately 3
minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH (F3)
or
MED (F2)
fan with a middle set
temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH (F3)
fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
COOL
mode and
LOW (F1)
fan with a middle set
temperature.
NOTE:
If you switch from a
COOL
setting to
OFF
or to
a fan setting, wait at least 3 minutes before switching
back to a
COOL
setting.
COOL Mode
Use the
FAN
at
HIGH (F3), MED (F2)
or
LOW (F1)
to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
FAN Mode
The vent control is located above the control
panels.
When set at
CLOSE
, only the air inside the room
will be circulated and conditioned. When set at
OPEN
, some inside air is exhausted outside.
Vent Control
To open the vent, pull the lever toward you.
To close it, push it in.
The side-to-side air direction is adjusted by moving
the lever to the left or right.
Air Direction—Side-to-Side
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Air Direction—Up and Down
Energy Saver
The energy saver switch controls the fan.
ON
—The fan and compressor cycle on and off
together. This results in wider variations of room
temperature and humidity. Normally used when
the room is unoccupied.
NOTE:
The fan will continue
to run for a short time after the compressor cycles off.
OFF
—The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at
OFF
in order to use
the fan settings (on the mode control).
