6
49-5000634 Rev. 1
Using the Air Conditioner
Remote Control
Ŷ
To ensure proper operation, aim the remote control at
the signal receiver on the air conditioner.
Ŷ
The remote control signal has a range of up to 20 feet.
Ŷ
Make sure nothing is between the air conditioner and
the remote control that could block the signal.
Ŷ
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions.
It must not be used when the outdoor temperature is
below 70
F.
Cool Mode
8VHWKH&RROPRGHDW
Auto, Quiet, Med, and High
fan
PRGHVIRUFRROLQJ8VHWKH
Tempe / –
pads to
set the desired temperature between 64°F and 86°F in
1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to a
Cool
setting or if turned from a fan setting
to a
Cool
setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
Cool
mode and
High
or
Med
fan with a middle set temperature.
For Maximum Cooling—
Select the
Cool
mode
and
High
fan with a lower set temperature.
For Quieter and Nighttime Cooling—
Select the
Cool
mode and
Quiet
fan with a middle set temperature.
Eco Mode
Controls the fan.
ON—
The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature
and humidity. When the unit first enters the operating
ECO
mode, either after the unit is turned on, by
changing the operating mode, or after a power failure,
the fan will run at the set fan speed for a minimum of
about 3 minutes, independent on whether or not the
compressor is on. After this 3 minute bellowing, the fan
and compresor will cycle on together for 2 minutes at the
set Fan speed, and then off for 10 minutes. This cycle
will repeat until the mode is changed.
NOTE:
the fan may continue to run for a short time or
may pulse intermittently after the compressor cycles off
to sample the room air.
OFF—
The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
8VHWKH
Fan
Only Mode at
Quiet, Med
or
High
fan speed
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
temperature cannot be entered. The room temperature
will appear in the display. Compressor is always off.
Auto Fan Mode
Set to
Auto
for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with
the set temperature.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling, the
fan speed will automatically decrease.
Dry Mode
Aids in removing humidity from the room.Dry mode cannot
be used to cool room.
NOTE:
In Dry mode, when the set temperature is close to
ambient temperature, the compressor may stop and the
fan will run in Quiet speed only.
Control Panel Lights On/Off Feature
This air conditioner has a control panel lights on/off
feature where its lights will turn off when there is no
activity with the controls for over one minute. To wake up
the controls, press any pad on the controls and the lights
will come on to show the previous settings.
To turn this feature off, press and hold the
SLEEP
pad,
on the unit, for 3 seconds. The unit will beep to signal
the successful toggle of the feature on and off.
USING THE
AIR CONDITIONER
Summary of Contents for AHTT06
Page 20: ...20 49 5000634 Rev 1 Notes ...
Page 42: ...20 49 5000634 Rev 1 Notas ...
