GE AHTT06, Owner'S Manual & Installation Instructions

49-5000634  Rev. 1

9

INST

ALLA

TION INSTRUCTIONS

Installation Instructions

Questions? Visit our Website at: GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

• 

IMPORTANT 

—

 Save these instructions for 

local inspector’s use.

• 

IMPORTANT 

—

Observe all governing codes 

and

ordinances.

• 

 Note to Installer

 – Be sure to leave these 

instructions with the Consumer.

•  

Note to Consumer –

 Keep these instructions for 

future reference.

•  

Skill level –

 Installation of this appliance requires 

basic mechanical skills.

• 

Completion time –

  Approximately 1 hour

•  We recommend that two people install this product.

•  Proper installation is the responsibility of the 

installer.

•  Product failure due to improper installation is not 

covered under the Warranty.

‡<RX0867XVHDOOVXSSOLHGSDUWVDQGXVHSURSHU

installation procedures as described in these 
instructions when installing this air conditioner.

TOOLS YOU WILL NEED

CAUTION

Do not, under any circumstances, cut or remove the 
third (ground) prong from the power cord.

Do not change the plug on the power cord of this air 
conditioner.

Aluminum house wiring may present special 
problems—consult a qualified electrician.

Power cord includes a current interrupter device. A 
test and reset button is provided on the plug case. The 
device should be tested on a periodic basis by first 
pressing the 

TEST

 button and then the 

RESET

 button 

while plugged into the outlet. If the 

TEST

 button does 

not trip or if the 

RESET

 button will not stay engaged, 

discontinue use of the air conditioner and contact a 
qualified service technician.

ELECTRICAL REQUIREMENTS

Some models require a 115/120-volt AC, 
60-Hz grounded outlet protected with a 
15-amp time-delay fuse or circuit breaker.

The 3-prong grounding plug minimizes the possibility 
of electric shock hazard. If the wall outlet you plan to 
use is only a 2-prong outlet, it is your responsibility 
to have it replaced with a properly grounded 3-prong 
wall outlet.

Phillips head screwdriver

Ruler or tape measure

Pencil

Level

Scissors or knife

UNPACKING THE AIR CONDITIONER

WARNING

EXCESSIVE WEIGHT HAZARD - 

When moving or 

lifting the air conditioner, use two or more people.  
Wear gloves when handling the air conditioner to 
protect against possible sharp edges and metal fins.

Remove Packaging Materials

•  Remove packaging materials. Save the carton and the 

foam packaging for storing the unit when not in use.

NOTE:  

There is NO internal packing material inside 

the air conditioner to remove - DO NOT open the 
cabinet.
•  Handle the air conditioner gently.
•  Keep the air conditioner upright and level. Do not 

set the air conditioner on its side, front, back or 
upside down.

•  The air conditioner must be standing upright for 2 

hours prior to installation and operation.

SUPPORT VIDEOS

Scan code for installation support 
videos.