29
11
Installation Instruction
11.1
Select of Installation Location
The inlet/outlet vents should be far away from the obstacles so that the air can flow all over the room;
Select the place where it is easy to drain condensed water or easy to connect with outdoor unit;
Be far away from heat source, steam and inflammable gas;
Select the place where it is possible to stand the weight of indoor unit without increasing the running
noise and vibration;
Ensure that the installation of indoor unit meets requirements in installation dimensions diagram;
Ensure that there should be enough space for maintenance or repair, distance between indoor unit and
floor should be over 200cm;
Place the unit to where 1m or more away from TV, Hi-fi and other electric appliances;
Place the unit to where air filter will be taken out easily;
It should be located at a place not affecting the neighbors with noise and air generated by discharging;
It should be installed in where with good ventilation;
No obstacles affecting the air inlet/outlet of the unit should be allowed around the outdoor unit;
The installation location should be able to bear the weight and vibration of outdoor unit and should
enable the safe installation;
It should be installed in a location free from leakage of inflammable or corrosive gas;
It is required that the installation of indoor unit meeting requirements on install dimensions diagram;
Install in the following place may cause failure. If it is unavoidable, contact with service
center please
Place where oil (machine oil) is used
The place where a lot of salinities such as coast exists
Place where a sulfured gas such as the hot spring zones is generated
Place where high-frequency waves are generated from radio equipment, welders and medical equipment
Other place with special circumstance.
Note:
1 Indoor unit
2 Outdoor Unit
