5.7.1
Save locations
Introduction
You can save files on several locations:
•
On the instrument
Amersham Imager 600 is equipped with a flash drive that allows for storage
of a finite number of images on the instrument. It is necessary to regularly re-
move images from the instrument to ensure available storage space. If the
instrument flash drive runs full, the oldest images will automatically be removed
when a new image is captured.
Note:
An external hard drive can be added to the USB port at the rear of the instru-
ment to expand available storage capacity.
Tip:
•
On an external USB flash drive
•
On a network drive
Network access is possible providing the instrument has been granted access
to the network location. For more details see
Section 4.4 Network, on page 74
.
Note:
Connect a USB flash drive
A USB flash driver is automatically installed when the USB flash drive is connected to
Amersham Imager 600.
Password protected USB flash drives are not supported.
Note:
Add new save location
Follow the instructions to add a location for file saving.
To enable access to a location for saving files over the network, the specific folder
must be shared and read/write privileges must be added for the Amersham Imager
600 instrument. See
Section 4.4 Network, on page 74
Note:
Action
Step
Select the settings icon in the top right hand corner of the screen:
1
Amersham Imager 600 Operating Instructions 29-0645-17 AD
149
5 Operation
5.7 Save and manage image files
5.7.1 Save locations
