1.3.3
Regulations for USA and Canada
NRTL certification
This symbol indicates that Amersham Imager 680 has been certified by a Nationally
Recognized Testing Laboratory (NRTL).
NRTL means an organization, which is recognized by the US Occupational Safety and
Health Administration (OSHA) as meeting the legal requirements of Title 29 of the Code
of Federal Regulations (29 CFR), Part 1910.7.
FCC compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
The user is cautioned that any changes or modifications not expressly approved
by GE could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be re-
quired to correct the interference at his own expense.
CAN ICES/NMB compliance
This product complies with the Canadian standard ICES-003/NMB-003 concerning
electromagnetic compatibility.
14
Amersham Imager 680 Operating Instructions 29271308 AB
1 Introduction
1.3 Regulatory information
1.3.3 Regulations for USA and Canada
