4.4.3
Instrument access from network
Amersham Imager 680 is equipped with a web tool which allows instrument access from
a network. The web tool can be used to copy or delete files on the instrument from a
remote location.
To be able to access Amersham Imager 680 web tool the following conditions must be
fulfilled:
•
The instrument and the computer must be connected through a local network.
•
The instrument's IP address must be known.
Your instrument's IP address is found in the Network view. Open the view by selecting
the settings icon in the top right-hand corner and then select the Network button in the
Settings view.
DHCP networks has a dynamic IP address assignment, therefore the IP address
may vary between connections. When using a DHCP network connection,
check regularly that the IP address is still accurate. If the IP address has
changed, use the new IP address in the Network view.
Note:
Access the web tool
Follow the steps below to set up and access files via the web tool.
Action
Step
Open the computer's web browser.
1
96
Amersham Imager 680 Operating Instructions 29271308 AB
4 Installation
4.4 Network
4.4.3 Instrument access from network
