Operating Instructions
Safety Instructions
Installation
Instructions
Tr
oubleshooting Tips
Consumer S
uppor
t
Troubleshooting Tips
Problem
Possible Causes
What To Do
Excessive smoking
Excessive soil.
•
Touch the
Clear/Off
pad. Open the windows to
rid the room of smoke. Wait until the
LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open
Oven too hot.
•
Allow the oven to cool below locking temperature.
after a clean cycle
Do not lock the door with the door latch except when
using the self-clean feature.
Oven not clean after a
Oven controls not properly set.
•
See the
Using the self-cleaning upper oven
section.
clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“Door” appears in the
Latch handle was moved to the
•
Move the latch handle to the right only when setting
display (on models
right but a program other than
the self-cleaning cycle.
with a door latch)
self-clean was selected.
“LOCK DOOR” flashes
The self-clean cycle has been
•
Close the oven door and on models with a latch, move
in the display
selected but the door is not
the latch all the way to the right.
closed and on models with a latch,
the latch was not moved all the
way to the right.
LOCKED DOOR light
The oven door is locked
•
Touch the
Clear/Off
pad. Allow the oven to cool
is on when you want
because the temperature
and then, on models with a door latch, unlock the door.
to cook
inside the oven has not
dropped below the
locking temperature.
“F—” and a number or
On models with a door latch,
•
The latch may have been moved, even if only slightly,
letter flash in the display
if a function error code appears
from the locked position. Make sure the latch is moved
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
You have a function error code.
•
Touch the
Clear/Off
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
•
Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven racks are
The nickel racks (if so equipped)
•
Apply a small amount of vegetable oil to a paper
difficult to slide
were cleaned in a self-clean cycle.
towel and wipe the edges of the oven racks with
The gray porcelain-coated racks
the paper towel. Do not spray with Pam
®
or other
(if so equipped) were improperly
lubricant sprays.
cleaned.
“Probe” appears in
This is reminding you to enter a
•
Enter a probe temperature.
the display (some models)
probe temperature after plugging
in the probe.
LOC shows in the
The Gas/Control Lockout feature
•
Be sure the surface burner controls are turned OFF.
display
is activated.
Turn this feature off to use the range. See the
Gas/Control
Lockout
section.
Before you call for service…
54