September 2004
2-12
Programming Site Data
Entering Global System
Data [GLOBL-SYSTM
Menu]
Refer to
Figure A-2
on page A-2, and complete the steps below to
enter system information in the
GLOBL
menu.
Selecting the
GLOBL-SYSTM Units
1.
Press
[ESC]
,
[ENTER]
,
[ESC]
in sequence to enter the
user program
.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until
GLOBL
appears and press
[ENTER]
.
4.
Press [
X
] until
SYSTM
appears and press
[ENTER]
.
5.
Enter a short
message
(up to 16 characters) by using the arrow
keys. Press [
W
]
and [
X
] to move the cursor to the desired location
and press
[
S
]
and
[
T
]
to select the desired character. Then press
[ENTER]
.
Selecting the System Units
1.
Press [
X
] to select the
system units
and press
[ENTER]
.
2.
Do one of the following:
•
1-Channel Meters
- go to
Setting Up the External Totalizer
Reset Switch
on the next page.
•
2-Channel Meters
- continue with the next step.
3.
Press [
X
] to select the volumetric units for the flow rate display
and press
[ENTER]
.
4.
Press [
X
] to select the number of digits to the right of the decimal
point in the volumetric flow rate display and press
[ENTER]
.
5.
Press [
X
] to select the desired units for the totalized flow rate
display and press
[ENTER]
.
6.
Press [
X
] to select the desired number of digits to the right of the
decimal point in the totalized flow rate display and press
[ENTER]
.
Summary of Contents for AquaTrans AT868
