4
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
■
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■
The remote control signal has a range of
up to 21 feet.
■
Make sure nothing is between the air
conditioner and the remote control that
could block the signal.
■
Make sure batteries are fresh and installed
correctly–see the
Care and Cleaning
section.
About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
Air Conditioner Controls
Remote Control
ON/OFF
Turns air conditioner on and off.
Display
Shows the set temperature, time remaining
on timer or fan speed
(1–LOW
,
2–MED
or
3–HIGH)
.
MODE
Use to set the air conditioner to
COOL
or
FAN
mode.
Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
COOL
mode.
FAN
Use to set the fan speed to
LOW (1), MED (2)
or
HIGH (3)
.
TIMER
ON–
When the air conditioner is off, it can be
set to automatically turn on in 1 to 12 hours
at its previous setting. Each touch will set the
time in hours.
OFF–
When the air conditioner is on, it can be
set to automatically turn off in 1 to 12 hours.
Each touch will set the time in hours.
To cancel the timer, press the
TIMER
pad
until the display time disappears.
Remote Control Signal Receiver
Remote Control
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The
TIMER
feature
will reset to the original setting. You may need to set
a new time if desired.
Power Outage Recovery Feature
Fan on
Cool on
Timer on
