![background image](http://html2.mh-extra.com/html/ge/brivo-oec-715/brivo-oec-715_service-manual_4191886295.webp)
Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
5-12
System provide tool to set imaging parameters. Click “Image Processing configure” tab on the main
screen, the image processing interface is displayed.
Changes on Image Brightness, Image Contrast, Black/Wihte Margin and Sharpen
power are not recommended because these values have been optimized for the image
quality to compromise any anatolomical imaging. Any changes will affect the system
image quality.
•
B/C Preference High Brightness or High Contrast: According to user’s preference to select
brightness enhance method.
•
Image Brightness: Pressing up or down arrow or dragging the block allows you to adjust image
brightness default from 0 to 100.
•
Image Contrast: Pressing up or down arrow or dragging the block allows you to adjust image
contrast default from 0 to 100.
•
Edge Enhance: Select default value of sharpening power from 0-9.
•
Rotation Angle: Select default value of image rotation angle from 0~359.
•
TNR (Temporal Noise Reduction): Select default value of noise filter from 0-3.
•
SM (Smart Metal) value: Select default value of the appearance reduction of metal in the image
from 0-50.
•
Enable or disable IP circular mask: it is used to assist beam alignment calibration. Make sure it is
set back to the default setting “Enable” after beam alignment.
•
Enable or disable IP shading correction image processing function.
Summary of Contents for Brivo OEC 715
