Installation Instructions
14
STEP 4 INSTALL ANTI-TIP BRACKET
(cont.)
Remove Grilles for Access to Power Cord and Anti-tip
Locking Hooks
Fresh Food Unit
• Open the access door.
• Using a 1/4" hex driver, remove the 2 screws
at the bottom of the grille.
• Pull the bottom of the grille forward, down and out
to remove.
Freezer Unit
• Open the access door.
• Using a 1/4" hex driver, remove the 2 screws
at the bottom of the grille on the right.
• Pull the bottom of the grille forward, down and out
to remove.
• Using a 1/4" hex driver, remove the screw
on the left side of the grille.
• The grille is aluminum and will bend easily. Gently pull
forward on the left side of the grille to open for access.
This grille will not be completely removed.
Power Cord
Locate the power cord inside the left cavity. If it has
not been adjusted so the plug is easily accessible,
do so now.
“L” Bolt
Left Grille Open
Power Cord Location
“L” Bolt
Left Grille Open
Power Cord Location
Move Unit into Final Position
• Move refrigerator toward its final installed location.
Align the tabs on the wall bracket with the openings
in the back of the unit.
• The unit has “L” bolts in the upper left and right
corners inside of the access compartment. These
bolts will interlock with the wall bracket and secure
the unit using the washers and hair pin cotters
in the hardware kit once the unit has been leveled
and is in the final position.
Screws
Screws
