– 12 –
Rangetop
To remove the rangetop:
Pull out the range from its installation.
1.
Remove the three 1/4-in. hex-head screws that
2.
attach the vent trim to the rangetop.
Lift and remove the vent trim.
3.
5. Raise the rear of the rangetop, then slide the
rangetop toward the rear of the range about 6
inches.
4. Remove the two 1/4-in. hex-head screws that
attach the rangetop to the range.
Vent Trim
Rangetop
(
Continued next page
)
Range Components
WARNING:
Sharp edges may be exposed when servicing. Use caution to avoid injury. Wear Kevlar gloves or
equivalent protection.
Lower Oven Drawer
The lower drawer can be removed by pulling the
drawer straight out until it stops, pressing the tabs
fi
rmly inward on both sides of the drawer rails and
pulling the drawer forward until disengaged from
the drawer guides.
The lower drawer can be installed by placing each
drawer rail around each inner rail guide and sliding
both in slightly to hook them, then
fi
rmly sliding the
drawer all the way in.
Strike
Roller Catch
Back of Drawer
Range Floor
Note:
When in the closed position, the strike on the
back of the drawer is captured by the roller catch.
The strike is riveted in place and is not adjustable.
The roller catch is attached to the range
fl
oor with
two 1/4-in. hex-head screws that, when loosened,
can provide a small amount of adjustment.