Installation Instructions
7 INSTALL MOTOR
9 INSTALL DUCT COVERS
To install the 12 duct cover alone:
• Place the 12 section of the decorative duct cover on
top of the hood.
• Secure the cover to the top of the hood with 4 screws
provided.
To install the 2-piece duct cover:
• Place the 2-piece duct cover on top of the hood.
• Secure the bottom cover to the top of the hood with
4 screws provided. See illustration, page 16.
• Extend the inside section upwards to meet the
ceiling and ceiling bracket.
• Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
8 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not
2-wire with a ground wire, a ground must be provided
by the installer. When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.
Motor Attachment Bracket
Motor Hooks
Install 2 Screws
Insert Tabs Into Slots
• Secure the support to the hood with screws as shown.
10 INSTALL FILTER SUPPORT
• Tip filter support into the rear of the hood.
• Insert support tabs into the slots at the rear of
the hood.
• Plug the motor connector into
the mating hood connector. See
the illustration for the hood
connector location. Touch the
hood to locate and make the
connection.
IMPORTANT:
Hold the
connector so the two square
corner terminals are at the top as you
position the connector to plug it in.
• Align and engage the
slots in the blower
assembly to the 3 hooks
at the rear of the
exhaust opening.
• Rotate motor upwards
until it aligns with the
attachment screw
location.
• Secure the motor to
attachment bracket
at the front of the
opening with washer
and screw provided.
• Use wire nuts to connect incoming ground to green,
white to white and black to black.
• Push wires into junction box and replace cover.
Be sure wires are not pinched.
White
Ground
Black
Check That White, Black and
Green Hood Wires Are Threaded
Thru Small Hole in Bracket
Remove
Junction Box
Cover
Insert Power
Conduit Thru
Strain Relief
and Tighten
Use UL Listed Wire Nuts
A
B
C
D
17
″
″
