CB Watch 3 User Manual
v6.3 - May 2019
Page 29 of 100
Overtravel
The overtravel is also monitored for each operation. This is defined as the difference (in
mm) between these two measured values:
-
The maximum travel point reached during the operation
-
The final resting position at the end of the operation
as measured by the travel sensor and shown on the travel curve
Figure 39
–
Monitoring the overtravel
HMI: Measurements/Last opening results and Last closing results
Figure 40
–
Displaying overtravel
An alarm threshold can be entered for the maximum overtravel: