GE Industrial Control Systems GEEP-124-I Copyright 1997,1998 The General Electric Company, USA
4
GEEP-124-I Horizontal Induction Motor
WPI, Antifriction Bearing
Reference Publications and
Standards
ANSI/NEMA MG-2
Safety Standards for construction
and Guide for Selection,
installation and Use of Electric
Motors and Generators.
ANSI C50.10
General Requirements for
Synchronous Machines.
IEEE 1
General Principles for
Temperature Limits in Rating of
Electrical Equipment.
IEEE 85
Test Procedure for Air-borne
Noise Measurements on Rotating
Machinery.
IEEE 112
Test Procedure for Polyphase
Induction Motors and Generators.
IEEE 115
Test Procedures for Synchronous
Machines.
Standards can be obtained by writing to the following:
National Electrical Manufacturers Association
2101 Street, N.W.
Washington, DC 20037
American National Standards Institute
1430 Broadway
New York, NY 10018
Attention: Sales Department
The Institute of Electrical and Electronics Engineers,
Inc.
445 Hoes Lane
Piscataway, NJ 08854
Attention: Publication Sales
Warranty considerations
The warranty coverage applicable to the
equipment specified under “Identification of Unit” may
be found in the corresponding sales contract.
The equipment must be operated in accordance
with nameplate specifications, applicable standards and
codes, and in accordance with this instruction manual
for the warranty to remain in effect during the warranty
period.
If a question or circumstance not covered by the
instruction manual occurs, or should a problem occur,
contact the nearest General Electric Technical Service
representative.
DLCGEEP-124-I/000, Approved, 2016-11-11, CampinasDM
