524
D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
DISTURBANCE RECORDER
CHAPTER 10: DIGITAL FAULT RECORDER
Trigger Position
Range: 1 to 100% in steps of 1
Default: 50%
This setting specifies the amount of pre-trigger data stored in a disturbance record
expressed as a percentage of the disturbance record length.
Maximum Re-Triggers
Range: 1 to 4 in steps of 1
Default: 2
This setting selects the maximum number of re-trigger records that can be generated
for a disturbance event. The value is limited to one less than the number of records that
can be stored (up to a maximum of four records).
Block Trigger
Range: any FlexLogic™ operand or shared operand
Default: OFF
When the operand assigned to this setting is asserted, all triggers to the disturbance
recorder are inhibited.
NOTE
NOTE:
When changes are made to the disturbance recorder settings, all existing disturbance
records will be cleared!
NOTE
NOTE:
The disturbance recorder will start collecting data upon power up or after the recorder is
cleared. If a trigger occurs immediately after a power up or the clearing of disturbance
records, and there is not enough pre-trigger data, then the pre-trigger will be set to the
amount of data collected and will not reflect the value specified by the user.
.
Figure 454: Disturbance recorder trigger logic
25
$&'5
',*&+75,**(5
',*&+75,**(5
',*&+75,**(5
$1/*&+75,**(5
$1/*&+75,**(5
$1/*&+75,**(5
25
',*&+5(75,**(5
',*&+5(75,**(5
',*&+5(75,**(5
$1/*&+5(75,**(5
$1/*&+5(75,**(5
$1/*&+5(75,**(5
25
6(77,1*
5HFRUG/HQJWK
7²SS
7,0(5
SS
75,**(56839
5(75,**(56839
)/(;/2*,&23(5$1'
&+$11(/75,**(5
)/(;/2*,&23(5$1'
&+$11(/5(75,**(5
25
',*&+$&7,9(
',*&+$&7,9(
',*&+$&7,9(
$1/*&+$&7,9(
$1/*&+$&7,9(
$1/*&+$&7,9(
)/(;/2*,&23(5$1'
&+$11(/$&7,9(
)/(;/2*,&23(5$1'
&+$11(/5(75,**(5
)/(;/2*,&23(5$1'
&+$11(/75,**(5
6(77,1*
0D[LPXP5H7ULJJHUV
,QFUHPHQW
5HVHW
&RXQWHU
)/(;/2*,&23(5$1'
5(75,**(56 0$;