10 - Specifications
UPS Type
:
LP 3-11
LP 5-11
LP 6-11
LP 8-11
LP 10-11
Output power (kVA/kW)
:
3/2.4 5/4 6/4.8 8/6.4 10/8
AC input voltage
:
220-240Vac
Input frequency
:
50/60 Hz
AC output voltage
:
230V
Output frequency
:
50 or 60 Hz, std. 50 Hz; selectable on front
System efficiency (full load)
:
88%
Line input breaker (MCB, D-type)
:
32A
32A
32A
40A
50A
Bypass input breaker (MCB, D-type)
:
32A
32A
32A
40A
50A
Input/output connectors
:
terminals at rear of unit
INPUT
AC input voltage range
at 100% load
:
172 - 285 V
at 50% load
:
147 - 285 V
at 25% load
:
132 - 285 V
Input frequency range
:
40-70 Hz
Input current wave form
:
sinusoidal
Input power factor
:
≥
0.99
Max. input current (A)
:
16
28
28
40
50
Inrush current
:
none
DC output voltage
:
380 V
BATTERY CHARGER
Characteristic
:
U/I-characteristic, constant current charging until float voltage, then constant
voltage charging and boost charge mode for fast recharging of batteries
DC input voltage range
:
350-450 V
DC output voltage at 20 °C
LP 3-11
:
float: 162.5 V boost: 177 V
LP 5/6/8/10-11
:
float: 274 V boost: 295 V
Output current limit (Adc)
:
2.0 2.0 2.0 3.6 3.6
OUTPUT CONVERTER
Output power at pf. = 0.8, VA*
:
3000
5000
6000
8000
10000
Semiconductor :
IGBT
AC output voltage nominal
:
220/230/240V (user selectable)
Output voltage tolerance
:
± 1% static resistive load
± 2% measured crest load 2.5:1
± 2% dynamic mean deviation over one half cycle for 100% of rated load
applied or removed
Typical overload
:
110%
≥
20 minutes
(temp. dependent)
130%
≥
3.5 minutes
150%
≥
2 minutes
Output frequency
:
60 or 50 Hz selectable, ± 0.1%, unless synchronized with the mains
Freq. tracking range
:
± 2/4/6% of nominal, user selectable
Output wave form
:
sine wave
Max. phase difference input-output :
max
7
°
Harmonic distortion
:
2% max. with linear load
Power factor range
:
Any lagging or leading power factor is permitted within the specified rating to
pf. 0.5
Output derating altitude
:
Till 1000m no derating
Above 1000m 12.5% per 1000m, max. 4000m
Protection
:
Automatic shut down (or transfer to bypass, if bypass is available) in case of
- low/high DC voltage
-
overtemperature
- overload / short circuit
The output is protected against connection to the mains
* according to EN 50091-1
OPM_LPE_11X_3K0_10K_1GB_V041
33
GE DE LP 11 UPS: User manual 4.1 (GB)
