GE H
EALTHCARE
D
IRECTION
2307224-100, R
EVISION
6
D
ISCOVERY
LS S
YSTEM
S
ERVICE
M
ANUAL
Page 134
Chapter 6 - Table
6.2.6.3 Attach the CT Template and Drill the Hole(s)
All table revisions use the CT template. Follow the instructions in this section to attach the CT Drill
Template, P/N 2355224, to the right secondary base side rail.
The "A" holes in the rail must be tapped in order to fasten the CT Drill Template to the rail. Refer to
and label the CT Drill Template holes.
Figure 6-29:
CT Drill Template Hole Labels (Viewed from the Rail Exterior)
1.) Refer to
. All table rail types have pre-drilled and partially tapped "A" holes.
a.) Locate the two "A" holes, between 395 and 565 mm from the rear edge of the rail.
b.) Use an M4 tap to finish the holes. (Tap from the interior of the table outward.)
Figure 6-30:
Finish Tapping the "A" Holes
"B" Holes (3 of 5)
Fasten to rail using "A" holes.
"B" Holes (2 of 5)
"C" Holes
"D" Hole
"E" Hole
CT Drill Template attaches to the "A" holes.
395 mm
from Rail Edge