[EN] English - K0457
Pressure calibrator operation (DPI 620) 5-1
Chapter 5: Pressure calibrator
operation (DPI 620)
5.1 Introduction
This section gives examples of how to connect and use the
pressure stations to do pressure calibrations with the DPI 620
calibrator and the applicable pressure modules (PM 620).
Before you start:
•
Read and understand the “Safety” section.
•
Do not use a damaged instrument.
Note:
Use only original parts supplied by the manufacturer.
5.2 Parts and
assembly
To make a fully integrated pressure calibrator instrument, use
these items:
•
a PV 62x pressure station; see Chapter 1 (Instrument parts,
accessories and options)
•
a DPI 620 calibrator; see Section 5.2.1
•
an applicable PM 620 module for the pressure station; see
Section 5.2.2
5.2.1 DPI 620 calibrator
parts
Refer to the user manual - K0449: Druck DPI 620 Advanced
modular calibrator.
1.
On or off button. Press and hold the button down until the
power comes on.
2.
Channel 1 (CH1) connectors for electrical measure and
source operations; refer to the user manual - K0449
3.
Isolated channel 2 (CH2) connectors for electrical measure
and source operations and a 24V loop power supply (24Vo);
refer to the user manual - K0449
4.
Rubber pull-down cover for the USB type A connector; USB
mini-type B connector and +5V DC power input socket.
5.
Colour display with touch-screen. The number of windows
you see on the display is set by the number of task selections
and external modules you are working with (maximum: 6).
To make a selection, lightly tap on the applicable display area;
refer to the user manual - K0449
6.
Sealed speaker unit.
1
2
3
6
4
5
