48
Before you call for service…
Problem
Possible Causes
What To Do
Excessive smoking
Excessive soil.
•
On models with touch pads, touch the
Clear/Off
pad.
On models with an
OVEN TEMP
knob, turn it to OFF.
Open the windows to rid the room of smoke. Wait until
the
SELF CLEAN
light goes off. Wipe up the excess soil
and reset the clean cycle.
Oven door will not open
Oven too hot.
•
Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after
Oven controls not properly set.
•
See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
Oven door will not
Oven is too hot.
•
Allow the oven to cool below locking temperature.
unlock (on models
Do not lock the door with the door latch except when
with a door latch)
using the self-clean feature.
Self clean light (on
The
OVEN TEMP
knob has not
•
Set the
OVEN TEMP
knob to
CLEAN
. See the
Using the
some models) blinks
been set to
CLEAN
when the
self-cleaning oven
section.
when trying to set a
latch was moved to the right.
self clean cycle
The latch was not moved to the
•
Move the latch to the right as far as it will go. See the
right when the
OVEN TEMP
knob
Using the self-cleaning oven
section.
was set to
CLEAN
.
Self clean light (on
A power interruption occurred.
•
Turn the
OVEN TEMP
knob to
OFF
and move the latch
some models) blinks
to the left as far as it will go. Reset the range controls
during self clean cycle
to the desired settings. See the
Using the self-cleaning
oven
section.
“Door” appears in the
Self-cleaning cycle has been
•
Move the latch handle all the way to the right.
display
(on some models)
selected but the latch handle
was not moved all the way
to the right.
Latch handle was moved to the
•
Move the latch handle to the right only when setting
right but a program other than
the self-cleaning cycle.
self-cleaning was selected.
“F—and a number or
On models with a door latch,
•
The latch may have been moved, even if only slightly,
letter” flash in the display
if a function error code appears
from the locked position. Make sure the latch is moved
(on some models)
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
You have a function error code.
•
Touch the
Clear/Off
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
•
Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Troubleshooting Tips
Operating
Instructions
Safety Instructions
Care and Cleaning
Installation
Instructions
Tr
oubleshooting T
ips
Consumer Support