Installation Instructions
REMOVE THE REFRIGERATOR DOOR (CONT.)
Remove the tape and tilt the door away from the
cabinet. Lift the door off of the center hinge pin.
Set the door on a non-scratching surface with
the outside up.
NOTE:
When removing the door, watch for washer(s)
between the center hinge and the bottom of the fresh food
door that may stick to the door.
Do not lose them.
CAUTION:
Do not let the door drop
to the floor. This could damage the doorstop.
1
F
G
REMOVE THE CENTER HINGE
Tape the freezer door shut with masking tape.
Remove the hex screws securing the center hinge
to the cabinet using a 10 mm socket ratchet/driver.
Lift the center hinge off of the freezer door.
NOTE:
When removing the hinge, watch for washer(s)
between the hinge and the door.
Do not lose them.
2
A
TRANSFER TOP HINGE
Using an adjustable wrench or Phillips
screwdriver, remove the hinge pin and washer(s)
from the bottom of the hinge. Turn the hinge
over and reinstall the hinge pin so it is on
the bottom of the hinge.
Reassemble the top hinge on the left side,
turning the screws just enough to hold the
hinge in place.
4
REMOVE FREEZER DOOR
Remove the tape and lift the door off
of the lower hinge.
Set the door on a non-scratching surface with
the outside up.
NOTE:
When removing the door, watch for washer(s)
between the bottom hinge and the freezer door that may
stick to the door.
Do not lose them.
CAUTION:
Do not let the door drop
to the floor. This could damage the doorstop.
3
B
C
Hex Screws
Center
Hinge
A
B
TRANSFER TOE KICK AND BOTTOM
HINGE
Using a Phillips screwdiver, remove the screws
securing the toe kick to the cabinet.
Pull the toe kick to remove it from
the refrigerator.
Transfer the slide plate from the left side
and install it on the right.
Using a 10 mm socket ratchet/driver, remove
the screws securing the bottom hinge to the
cabinet.
Using an adjustable wrench or Phillips
screwdriver, remove the hinge pin and
washer(s) from the right side of the bracket
and install it on the left.
Install the bottom hinge on the left side
of the cabinet.
Place the toe kick back onto the front of the
refrigerator cabinet. The cutout will go around
the bottom hinge pin.
Secure the toe kick with the screws removed
earlier.
5
A
B
C
D
E
F
Screw
Screw
Screw
Screw
Bottom Hinge Pin
G
H
11
A
B
Hex Screws