Installation Instructions
REVERSING THE DOOR SWING
2
REMOVE THE FREEZER DOOR
Tape the door shut with masking tape.
Remove the center hinge by removing the screws. Lift
up the hinge to remove it.
NOTE: Some models have a washer between the
center hinge and the top of the freezer door. Be careful
not to lose them.
Remove the tape holding the door shut.
Lift the freezer door up and off the bottom hinge.
Set the door outside-up on a non-scratching surface.
NOTE: When removing the door, watch for washer(s)
between the bottom hinge and the bottom of the
freezer door that may stick to the door. Do not lose.
NOTICE:
Do not let door drop to the floor. Doing so
could damage the door stop.
10
3
BOTTOM HINGE
Remove the screws and bottom hinge from the right
side. Remove the screw covers from the left corner.
Using the left hinge included with the parts that came
with your refrigerator along with the screws (and
washers if applicable) removed earlier, install the left
hinge onto the bottom left of your refrigerator.
Place the screw covers into the holes now vacant on
the right.
1
REMOVE THE FRESH FOOD DOOR
Remove the hinge cover. Unscrew and remove the top
hinge.
Lift the fresh food door
up and away from the
appliance.
Set the door on a non-
scratching surface with
the outside up.
NOTICE:
Do not let door drop to the floor. Doing so
could damage the door stop.
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for the doors.
• It is recommended that 2 people perform this task.
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from the
ULJKWVLGHWRWKHOHIWVLGH³LI\RXHYHUZDQWWRFKDQJH
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves.
TOOLS YOU WILL NEED
8 mm Socket driver
Phillips screwdriver
Putty knife or
thin-blade screwdriver
Masking tape
Summary of Contents for GBE10ESJSB
Page 15: ...15 Notes GEAppliances com...
Page 47: ...47 Notas GEAppliances com...
Page 48: ...48 Notas...
Page 49: ...49 Notas GEAppliances com...
