Installation Preparation
6
UNPACKING THE COMPACTOR
1
• Move the compactor close to the installation
location.
• Use a section of the shipping carton to protect
the finished floor.
• Do not use the handle to lift the compactor.
• Remove all protective packaging materials such
as tape or shipping pads. Remove waxy residue
caused by shipping material with a mild solution
of liquid household cleaner and water.
• Check that the power supply cord is attached to
the cord clip on the rear of the compactor.
IMPORTANT:
Use the shipping carton as a pad.
Do not slide the compactor across a finished floor.
Damage will occur.
Cord clip
REPLACING THE DOOR TOEKICK
(Optional for ZCGS150SS and
ZCGP150II Models Only)
2
• Open the compactor drawer and remove any
shipping materials or other items shipped in the
drawer.
• Do not remove the compactor bag (if installed).
• Grasp the sides of the drawer and lift it out of the
compactor. Place the drawer on a protected
surface. The drawer can scratch a finished floor.
ZCGS150SS and ZCGP150II Models are supplied
with extra toekicks that can replace the toekicks
assembled on the compactor.
• Lay the drawer on its side.
• Remove 2 foot pedal screws on the side of
the drawer. Lift off the foot pedal.
• Remove 2 door toekick screws. Remove door
toekick.
• Install the new door toekick using the original
screws.
• Reinstall the foot pedal using the original screws.
See Step 5 for instructions on replacing the top
toekick and base toekick.
Door
Toekick
screw
Door
Toekick
screw
Door
Toekick
Foot pedal
