TM
Specification Revised 1/03
PTC22MBM – GE Profile
™
21.9 Cu. Ft. CustomStyle
™
Top-Freezer Refrigerator
Case Dimensions (in inches/cm.)
69-7/8
68-3/4
35-3/4
28-3/8
23-3/4
61
26-3/4
38-1/4
25"
Counter
Top
Electrical
Water
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24-1/2"* Side panels
24"
Cabinet
8' Ceiling
13" to 14"
Cabinet
12"
Soffit
70-1/4"*
36"
24"
Standard, New Construction and Replacement Installation
Installation Tips to Maximize the Built-In Look
• All wall/floor moulding should be removed prior to installation.
• Water recess on rear wall recommended to prevent water line damage.
48" minimum length 1/4" diameter water line tubing recommended.
• When possible, recess both copper water line and electrical outlet.
(See local codes)
• Front and rear leveling legs are adjustable for the built-in look.
(See owner’s manual)
Handle Side Clearance
– At least 2" (51 mm) on the handle side for fingertip clearances.
Top and Bottom Clearance
– At least 3/16" (4.75 mm) at the top and bottom edges to allow for trim flange.
Hinge Side Clearance
– The installation of 3/4" (19 mm) thick side panels requires less clearance
because the space between the door and adjacent countertop is wider.
• To avoid door contact to countertop consider:
– Miter the corner of the adjacent countertops 45°, or pull the refrigerator
forward enough to avoid contact.
Rough-In Dimensions (in inches/cm.)
IMPORTANT:
Before finalizing specifications for your GE Profile Performance
™
CustomStyle
™
Refrigerator, Please NOTE:
• A minimum of 36" is required for refrigerator installation
• Be sure to allow for 1/2" or 3/4" side panels in addition to the 36" minimum
Top View
Front View
R
Total volume and shelf
area are calculated by the
Association of Home
Appliance Manufacturers’
standards.
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
™
or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
