GE GE universal remote, Instruction Manual

3

Battery Installation

1.  On the back of the remote, push down on the 

tab and lift the cover off.

2.  Match the batteries to the + and - marks inside 

the battery case, then insert 2 AAA Alkaline 

batteries.

3.  Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons 

are depressed more than 30 seconds. This will 

save your batteries should your remote get stuck in 

a place where the buttons remain depressed (e.g., 

between the sofa cushions).

Code Saver

You will have up to 10 minutes to change the 

batteries in your remote without losing codes you 

have programmed. However, do not press any 

buttons until batteries are installed in the remote. 

If buttons are pressed without batteries in the 

remote, all codes will be lost.

Code Setup

The 

SETUP 

button is used to setup the remote. 

You can either setup the remote using the code 

tables (on separate sheet), or you can search 

through the library of codes until you find a code 

that works for your product.

Please refer to “ Code 

Search” on page 7 for more information on using 

the code search feature to learn how to search 

through the library of codes for your products.

NOTE: You can store any kind of code under any 

mode (except TV). I.e., you can store a DVR code 

under the 

CBL/SAT 

button, or a Cable code under 

the 

DVD/DVR 

button, etc. However, you can only 

store TV codes under the 

TV 

button.

  Setup