02
Product Enclosure:
1. Do not apply mechanical load to the terminals, otherwise the terminals can be damaged.
2. All labels and warning marks should be visible after the installation. Do not scrawl, damage, or
cover any label on the device.
3. Do not touch the running equipment to avoid being hurt as its temperature may exceed 60°C. Do
not install the equipment at a place within children's reach.
4.
Unauthorized dismantling or modification may damage the equipment, the damage is not covered
under the warranty.
5. Do not start the BACK-UP function if the inverter is not connected to the battery.
6. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD.
Disconnect all incoming power and
turn off the product before working
on it.
Delayed discharge. Wait 5 minutes
after power off until the components
are completely discharged.
Read through the guide before
working on this device.
Potential risks exist. Wear proper PPE
before any operations.
High-temperature hazard. Do not
touch the product under operation
to avoid being burnt.
Grounding point. Indicates the position
for connecting the PE cable.
CE marking
Do not dispose of the inverter as
household waste.Discard the product
in compliance with local laws and
regulations, or send it back to the
manufacturer.
5min
Check Before Power On
No.
Check Item
1
The product is firmly installed at a clean place that is well-ventilated and easy-to-
operate.
2
The PE, DC input, AC output, and communication cables are connected correctly and
securely.
3
Cable ties are intact, routed properly and evenly.
4
Unused ports and terminals are sealed.
5
The voltage and frequency at the connection point meet the inverter grid connection
requirements.
