36
11. Remove the steam nozzle.
12. Remove the four 1/4 in. hex screws that hold the
rear drum support to the side panels.
13. Lift the front drum support out of the key holes.
Drum Roller
The dryer uses four rollers to support the drum. The
rollers can be replaced by removing the triangular
FODPSDQGSXOOLQJUROOHUVRȺ
Motor
7KHPRWRULVORFDWHGRQWKHGU\HUÀRRURQWKHOHIW
side.
Operating Voltage: 120 VAC Reversible
Horsepower: 1/3
R,P.M.: 1725
Main Winding Resistance
ű
Start Winding Resistance
ű
The motor is used to drive the drum and blower
wheel. Motor reversal is accomplished by the drum
reversing relay located on the main control board.
The relay swaps the location of line and neutral.
The motor has two centrifugal switches that are la-
beled A and B on the schematic. Switch A controls L2
to the heater, and switch B connects L1 to either the
start winding when the motor is not running or to the
main control board when the motor is running.
Motor Connector
2 6 8 4 3 9 7 5 1
GND
Pin 1: Centrifugal Switch A input
Pin 2: Centrifugal Switch A output
Pin 3: Centrifugal Switch B N.C.
Pin 4: Main winding neutral
Pin 5: Main winding L1
Pin 6: Centrifugal Switch B N.O.
Pin 7: Start Winding (Aux 2)
Pin 8: Start winding (Aux 1)
Pin 9: Motor TCO output
Motor Removal
1. Disconnect power from the unit.
2. Remove the control panel.
3. Remove the front panel.
4. Remove the trap duct.
See Rear Duct Removal on page 39.
See Nozzle Holder Removal on page 49.
See Motor Location on page 19.
See Motor Direction 1 Highlight on page 51.
See Motor Direction 2 Highlight on page 52.
See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
