39
Inlet Ring
Inlet Ring Removal
1. Disconnect power from the unit.
2. Remove the control panel.
3. Remove the front panel.
4. Remove the trap duct.
5. Remove the three 1/4 in. hex screws that secure
the inlet ring to the trap duct.
6. Pull the upper right side of the ring slightly for-
ward, then upward to disengage the ring from
the tab.
Fan Housing
Blower Housing Removal
1. Disconnect power from the unit.
2. Remove the control panel.
3. Remove the front panel.
4. Remove the trap duct.
5. Remove the inlet ring.
6. Remove the reverse thread blower wheel back-
up nut.
7. Unscrew the reverse thread blower wheel.
14 mm
Back-up Nut
Rear Duct
Rear Duct Removal
1. Disconnect power and water from the unit.
2. Remove the control panel.
3. Remove the top panel.
4. Remove the rear panel.
5. Remove the two #2 Phillips screws on the front
side of the drum support that attach the rear
duct to the rear drum support.
See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
See Trap Duct Removal on page 38.
See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
See Trap Duct Removal on page 38.
See Inlet Ring Removal on page 39.
See Control Panel Removal on page 20.
See Top Panel Removal on page 24.
See Rear Panel Removal on page 26.
