– 53 –
NOTE: When reinstalling the nozzle to the
gasket, it may be helpful to remove the nozzle
from the hose. Ensure that the washer is placed
on the outside and that the nozzle is aligned
with the indent on the inside of the gasket.
3. Loosen the 7 mm bolt that holds the wire and
bolt assembly to the outer tub lip. Remove the
wire and bolt assembly from the tub gasket.
NOTE: When reinstalling the wire and bolt,
tighten to a gap of approximately 1¼ inches (as
shown). Do not overtighten.
4.
3XOOWKHWXEJDVNHWRȺWKHRXWHUWXEOLS
NOTE: When reinstalling the tub gasket on the
outer tub, align the notch in the gasket with the
arrow located on the top of the outer tub lip
before tightening the wire and bolt assembly.
Gasket Outside
Gasket Inside
Washer
Indent
Nozzl
Indent
Nozzle
Washer
Wire and Bolt Retainer
1
1
/
4
-in. Gap
1¼ in. Gap
Wire and Bolt Retainer
Outer
Tub
Lip
Outer
Tub
Lip
Arrow
Notch
Arrow
Notch