– 59 –
Service Test Mode
The washer control has a service test mode that can be utilized by the service technician in order to test
critical components and to access error codes. This test mode will help the service technician to quickly
identify failed or improper operation of washer components.
Caution: Testing is accomplished through built-in test procedures. Unplugging components for testing can
damage component connections.
Machine must be in idle mode before entering a test. Idle mode occurs when the washer has completed a
cycle. If the cycle is interrupted, the washer will drain water when the power is reapplied. The water must be
emptied BEFORE the test mode can be entered. If water remains in the washer, manually drain the washer to
empty. A failed water level switch can cause an inability to enter the service test mode.
To enter the test mode:
To exit the test mode:
1. Begin with the washer in idle mode (all LED's
RQWKHGLVSOD\RȺ
2. Press the following key sequence to enter
service mode, depending on the model:
• Temp -->Delay Wash -->Temp -->Delay Wash
• Signal -->Extra Rinse -->Signal -->Delay Rinse
• Temp -->Delay Start -->Temp -->Delay Start
NOTE: The sequence must be done in order. If
there are any other button presses or buttons
pressed out of order, the sequence must be
started from the beginning. Test t01 will show
in the display.
1. Press Power button.
NOTE: Attempting to exit the service test mode
by disconnecting the power will result in a locked
washer.
Test Mode
Description
t01 Model ID
9HUL¿HVRUVHWVRQQHZERDUGWKHSURSHUPRGHO,'
t02 Fault Codes
Lists up to 10 control-detected problems
t03 Software ID
9HUL¿HVXVLQJODWHVW8/FRGH²&RQWURO³
Inverter
software
t04 LED Illumination and Button Test
9HUL¿HVWKDWDOOGLVSOD\VDQGEXWWRQVZRUN
t05 Pump Test
Operates pump
t06 Water level sensor
)LOOVWRDOO¿OOOHYHOVWKHQSXPSVRXWZDWHU
t07 Thermistor/Heater Test
9HUL¿HVWKDWERWKWKHWKHUPLVWRUDQGKHDWHUZRUN
t08 Steam test
9HUL¿HVKRWZDWHUYDOYHZRUNV
t09 Spray test
9HUL¿HVFROGZDWHUYDOYHZRUNV
t10 Tumble Test
9HUL¿HVZDVKHUWXPEOHVLHZDVKF\FOH
t11 Spin Test
9HUL¿HVZDVKHUVSLQV
t12 Dispenser Test
9HUL¿HVGLVSHQVHU¿OOZRUNVIRUDOOIRXU¿OOPRGHV
t13 EOL Test
Performs factory end-of-line test sequence