– 52 –
/LG/RFN'LDJQRVWLF2YHUYLHZ
Any time the lid is in the down position, the lid
actuator presses down on lid lock mechanism.
When the washer goes into the spin or rinse
portion of a cycle, a lock routine will occur.
The control will send 120 VAC from J513 pin 1
to the lid lock heating the lock PTC. The lock
PTC will remain energized while the lid is locked.
This will close the bimetal switch completing the
circuit.
When the lid is closed, the lid lock engages the lid
actuator and prevents opening the lid during the
spin cycle and while the basket is spinning.
The lock will be released approximately 5
seconds after the basket stops spinning.
NOTE:
If there is a power outage the lid lock can
take 3 minutes to release.
The lid lock is attached to the top cover assembly
with two Phillips-head screws. (See
Top Cover
Assembly
in the
Washer Components
section
of this service guide.) The lid must be open to
access the screws. The top cover assembly must
be raised approximately 4 inches to remove the
lid lock.
The lid lock is connected to the washer with a
wire harness.
Disconnect
Lid Lock
Lid Actuator
Lid Lock
(below
opening)
(Continued Next Page)
Lid Lock
Summary of Contents for GUD24ESSMWW
