49-1000352 Rev. 3
5
Control Settings
The temperature range of the wine center/beverage and
ZLQHFHQWHULVLQWHQGHGIRU)&WR)&
The display shows the average temperature of the
appliance. It is normal for the actual temperature to vary
slightly during operation.
Auto Temperature Setting
For GVS04 Beverage and Wine Center:
When the
DSSOLDQFHLVSOXJJHGLQRUWKH³´SDGLVSUHVVHGWKH
DSSOLDQFHUXQVRQWKH³$XWR%HY´VHWWLQJRI)&
DQGWKH³$XWR%HY´LQGLFDWRUOLJKWLQWKHXSSHUOHIWFRUQHU
stays lit.
For GWS04 Wine Chiller:
When the appliance is
SOXJJHGLQRUWKH³´SDGLVSUHVVHGWKHDSSOLDQFHUXQV
RQWKH³5HG´ZLQHVHWWLQJRI)&DQGWKH³5HG´
wine indicator light in the upper left corner stays lit. If
the "-" pad is pressed, the appliance runs on the "white"
ZLQHVHWWLQJRI)&DQGWKH:KLWHZLQHLQGLFDWRU
light in the upper middle stays lit.
NOTE:
'LVSOD\ZLOOIODVKZKHQWKH³´SDGLVSUHVVHG
Normal Temperature Setting
The temperature of the appliance can be set anywhere
EHWZHHQ)&WR)&E\WKH³´DQG³±´
pads.
1. Press and hold the SET pad. You will hear a series of
2 beeps.
$IWHUWKHVHFRQGEHHSSUHVVWKH³´DQG³±´SDGV
to increase or decrease the desired temperature in
LQFUHPHQWVRIRQHGHJUHH'XULQJWKLVWLPHWKHGLVSOD\
will flash.
3. Press SET to confirm your choice. The display will stop
flashing. If no confirmation is made in ten seconds, the
unit will automatically accept your change.
NOTE:
When you change the temperature setting, there
may be a 5-minute delay until the compressor starts to run.
Fahrenheit and Celsius
The temperature display can be changed between
)DKUHQKHLWDQG&HOVLXVE\SUHVVLQJDQGKROGLQJWKH³´
pad for approximately 5 seconds.
Indicator Light
The indicator is lit when the compressor is running to
cool your unit. It will not be lit when the compressor is
idle.
Interior Light
To switch the interior light on/off, simply press the
pad.
When the Wine Center/Beverage and Wine Center is Plugged In
After plugging in the wine center/beverage and wine
center and setting the desired temperature, allow the
appliance to reach the set temperature before loading
your wine. The temperature may take up to 12 hours to
FRPSOHWHO\VWDELOL]H
After loading the wine and/or beverages, you may notice
the actual temperature rise. This is normal. The actual
temperature will continue to change as the wine and/
or beverages are cooled to the set temperature. The
temperature may take up to 12 hours to completely
VWDELOL]H
A guide with wine serving
temperature suggestions is
located on the inside right
portion of the unit. It gives
recommended temperatures
for different wines, as well
as instructions on adjusting
the temperature of the wine
center/beverage and wine
center
NOTE:
The exterior of the
cabinet may get warm. This
is normal.
Interior Light
You can turn the light
ON
or
OFF
by pushing the light
switch located on the right side of the control panel
housing. If the interior light is left on, it will raise the
inside temperature.
Controls
USING THE
APPLIANCE:
Controls
Auto Bev
Indicator Light
Red
White
Red Wine
Indicator Light
White Wine Indicator Light
GVS04 Beverage and Wine Center
GWS04 Wine Chiller
