Installation Instructions
10
CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assembly, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 24 volt-60Hz electric
power. The included transformer changes
standard 120-volt AC house power to 24 volts.
Plug the transformer into a 120-volt outlet only.
Be sure the outlet is always live so it can not be
switched off by mistake.
• Replace the top cover.
• Replace the salt hole cover.
9
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
CONTROL SETTINGS REQUIRED
upon installation
and after an extended power outage.
NOTES:
• WHEN THE TRANSFORMER IS PLUGGED INTO THE
ELECTRICAL OUTLET, 12:00 PM (flashing), and
PRESENT TIME
is displayed. Program the control
as instructed below.
If
- - - is flashing
, use the UP
button to
set the correct model code as follows:
F30
for
GXSF30H. If you pass by the correct code number,
use the DOWN
button. Then press the
MODE
button to accept the correct model.
• A “beep” sounds while pressing buttons for control
programming. One beep signals a change in the
control display. Repeated beeps mean the control
will not accept a change from the button you have
pressed, and you should select another button.
• To program the control, you will use the UP
,
DOWN
and
MODE
buttons.
• Use the
MODE
button to select the desired control
function.
SET PRESENT TIME OF DAY
1.
Press the
MODE
button until
PRESENT TIME
appears in the
display.
2.
Press UP
or DOWN
button to set. The UP button
advances the time; the DOWN
button moves the time in
reverse.
If the present time is between noon and midnight,
be sure PM shows in the display. If the present
time is between midnight and noon, be sure AM
shows in the display.
NOTE:
Each press of an UP
or DOWN
button
changes the time by one minute. Holding the
button changes the time at a rapid rate.
3.
When the present time is correct, press
MODE
to
accept.
SET WATER HARDNESS NUMBER
1.
Press the
MODE
button until
HARDNESS
appears in the
display.
2.
Press UP
or DOWN
button
to set your water hardness number in the
display. DOWN decreases the hardness value.
UP increases the hardness value.
NOTE:
Each press of a button changes the display
by 1, between 1 and 25. Above 25, the display
changes 5 at a time (25, 30, 35, etc.). Holding a
button in changes the numbers at a rapid rate.
Summary of Contents for GXSF30H
Page 24: ...24 Parts list ...
Page 52: ...52 Notas ...
Page 53: ...53 Notas ge com ...
Page 55: ...55 ge com ...
