3.7.1.5 How to activate Screen Lock
1.
Invoke System Setup as described in
.
2.
On the left side of the screen select
General
and then click the
General
Settings
tab.
3.
Check mark "Screen Lock".
a.
If no password previously entered, following dialog appears.
Figure 3-61 change password
b.
Enter "New Password".
c.
"Retype new Password" and then click
Save&Exit
to save new screen lock password.
4.
Close the Service page with
Save&Exit
and restart the system.
Note
A new screen lock password must be at least 6 characters long and has a maximum length of 80 characters.
The password must contain at least 2 non-letter characters, 0...9 or !@#$%^*().
Note
If screen is locked you have to enter the password to get full system control. If password is unknown click
Emergency. This enables standard - but limited - operation.
Note
The Screen Lock password cannot be reset by the user! Please contact your GE service representative.
3.7.1.6 How to change Video Norm
1.
Invoke System Setup as described in
.
2.
On the left side of the screen select
Connectivity
and then click the
Peripherals
tab.
3.
Click the proper field: PAL (50Hz) or NTSC (60Hz); see
.
4.
Close the Service page with
Save&Exit
and restart the system.
3.7.1.7 How to change Ext. Monitor Video Signal
1.
Invoke System Setup as described in
.
2.
On the left side of the screen select
Connectivity
and then click the
Peripherals
tab.
3.
If not currently selected, click the proper field; see
4.
Close the Service page with
Save&Exit
and restart the system.
3.7.1.8 How to change Recorder Type
1.
Invoke System Setup as described in
.
2.
On the left side of the screen select
Connectivity
and then click the
Peripherals
tab.
3.
Depending on the used Recorder type, click the proper field. Refer to
.
4.
Close the Service page with
Save&Exit
and restart the system.
3.7.1.9 How to adjust function of the Footswitch
1.
Invoke System Setup as described in
.
2.
On the left side of the screen select
Connectivity
and then click the
Peripherals
tab.
3.
Select desired function of the Footswitch. Refer to
.
4.
Close the Service page with
Save&Exit
and restart the system.
3.7.1.10 How to change the Keyboard Layout
see
Section 6.4 "Modification of Keyboard Layout" on page 6-7
Setup Instructions
3-60
Voluson E-Series Service Manual
KTD106657 Revision 2
Summary of Contents for H48681XB
