HANDHELD DISPLAY
MM300/MM200 PROGRAMMING TECHNIQUES USING THE HHD
HANDHELD DISPLAY – INSTRUCTION MANUAL
15
3 MM300/MM200 programming techniques using
the HHD
To streamline the setting entry process, the HHD omits non-functional settings from the
display.
CAUTION
CAUTION:
Settings may be changed while the motor is running. However, appropriate measures
must be taken to limit the consequences of entering unintended or misunderstood
setting values. Consequences of inappropriate settings to the specific application at
hand include loss of protection, loss of control, and undesired starting or stopping.
3.1 Enumeration setpoints
Enumeration settings select from a limited set of values (for example, enabled or disabled).
The following procedure describes how to edit an enumeration setting.
1.
Use the soft-keys to select the relevant setting page.
2.
Use the UP and DOWN keys to select the relevant setting field.
3.
Press the
ENTER
key. A popup window will appear with a list of available values.
4.
Use the
UP
and
DOWN
keys to select from the available values. If there are more than
seven available values, then an arrow indicator will appear on the lower right of the
popup to indicate additional selections.
5.
Press the
ENTER
key when complete to exit the edit sequence. The selection will be
automatically saved.
6.
Press Esc to cancel the edit and leave the setpoint unchanged.
Figure 21: Enumeration setpoint editing
Label of
setpoint being
edited
Indication of additional
setpoint values
