September 2007
8
HygroTrace Moisture Transmitter
Digital Communications Wiring Connections (cont.)
3.
Trim any unused leads back to the outer cable jacket in order
to remove the bare tinned wire and prevent accidental short
circuits.
The
HygroTrace
is now ready for operation.
Note:
To remove the probe cable, pull back the spring-loaded
sleeve and pull the cable out of the connector.
Powering Up
After the
HygroTrace
is wired as described in the previous
sections, power may be applied to the unit. The transmitter takes
up to 60 seconds to initialize and begin normal operation. If the
sensor has been exposed to ambient conditions of less than
10% RH for less than 72 hours, the
HygroTrace
will meet its
specified accuracy within 24 hours following startup.