3-24
6" QuickPanel* View Basic, Monochrome, Thin Bezel – September 2010
GFK-2328B
3
The QuickPanel View provides two methods for setting an IP address:
DHCP (Dynamic Host Configuration Protocol). This is the default
method that is carried out automatically.
Note:
There must be a DHCP server on the connected network for a
valid IP address to be assigned. Contact your network
administrator to ensure correct DHCP server configuration.
Manual method.
You uniquely specify the numeric addresses for the
QuickPanel View, the Subnet Mask, and the Default Gateway (if
applicable).
DHCP is the default on LAN1. The default on LAN2 is Manual with a setting of
IP address 192.0.0.1 subnet mask of 255.255.255.0 and no gateway.
Note:
Use a crossover cable to connect the QuickPanel View directly
to a PC. When connecting to a LAN HUB, use a
straight-through cable. Contact your network administrator for
further information.
To set an IP address
1. From
the
Control Panel
, tap
Network and Dial-up Connections.
2. The Connection window appears.
3. Select
a
connection and choose
Properties. The Built-in
Ethernet Port Settings dialog box appears.