9
INSTALL THE ICEMAKER FILL CUP
Install the
icemaker fill cup
(side-mounted) (17) into
the icemaker as shown.
5
17
MOUNT THE ICEMAKER
•
Lift the icemaker so the
fill tube extension
(10) fits in the
fill cup
(E) opening. Hang the
icemaker
on the two
mounting screws
(C).
Make sure:
•
The power cord is still firmly in the socket.
•
The
fill tube extension
(10) is still in the fill cup
opening. (Check the rear of the refrigerator to
make sure the fill tube has not been pushed out
of the back of the refrigerator).
•
The icemaker mounting screws are located in
the uppermost position of the mounting slots.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
7
10
E
C
POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List
on page 7. Plug the female end of the
power cord
adapter
(20) onto the male terminals on the
icemaker power cord. When connecting the adapter
to the power cord, make sure the seal is in place
between the connectors. Secure the power cord
adapter to the icemaker by putting it into the hook
at the back of the icemaker and attaching it to the
icemaker with a
wire tie
(23).
4
PLUG IN THE ICEMAKER
Place the icemaker in the freezer compartment on its
side as shown. Insert the
icemaker power cord plug
(D) into the socket on the side wall, making sure the
prongs and holes are matched. Press the plug firmly
into the socket.
6
D
8
11
ATTACH WARRANTY LABEL
A
label
(9) is provided with this kit to record the date
of installation for warranty purposes. Apply it to the
back of the refrigerator.
9
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner’s Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
10
Hook
Hook
Wire tie
Seal
Installation Instructions
INSTALL THE ICE BUCKET
Put the
ice bucket
(11) directly under the icemaker
(to the left and all the way to the rear of the shelf
under the icemaker).
Make sure the icemaker power switch is set to
O
(off).
20
