GE Interlogix 0150-0265A, User Manual

GE Interlogix 

ProBridge Gateway 

12 

0150-0265A / August 2003 

Source    

0x00-0xFD keypad address <= Impac Mux/DVMRe 

Camera number 

Mapped camera: 32 Cameras/Zone 

Pan information       0x00: No Pan movement; 0x01 to 0x20: Pan Left at speed 1 

to 32...  

Tilt information         0x00: No Tilt movement; 0x01 to 0x20: Tilt Down at speed to 

32... 

Zoom information 

0x00: No Zoom; 0x80+(0x01 to 0x20): Zoom In at speed 1 to 
32... 

Checksum 

2’s complement

4.1.3.2  I

RIS AND 

F

OCUS

(No Speed Values)

There is a motor start and motor stop command associated with each of the 4 
functions to be controlled:  

Iris Open, Iris Close, Focus Near, Focus Far

.  A 

message is generated each time one of these four keys are pressed or released.  
The ProBridge Gateway converts these messages to 312 messages as follows: 
      

Port 0:

 Example with Iris Close (Start) on WaveReader 

Motor Message format:  

Synchronization  

0xFF 

Length 

0x07 

Message type 1 

0x09 

Message type 2  

0x05 

Destination 

Impac Mux/DVMRe  

Source    

Impac Mux/DVMRe 

Camera number 

Camera connected to Mux/DVMRe (00-0F) 

Motor command 

Iris Close Start (Impac motor command) 

Checksum 

2’s complement

Port 1:

  Iris, Focus message at KTD405 

      
     Message format: 

Synchronization  

0xFF 

Length 

0x07 

Message type 1 

0x20 Digiplex message 

Message type 2  

312 command code  
CMD312_IRIS_CLOSE(C) (Start) 

Destination 

Mapped camera: 0x80-0xFD* 0x80 + camera # high byte  

Source    

0x00-0xFD keypad address <= Impac Mux/DVMRe 

Camera number 

Mapped camera: Camera (site) # low byte 

“Monitor “ value 

0 (General command parameter) 

Checksum 

2’s complement

4.1.3.3  M

OUSE

T

RAK 

C

OMMAND

: 

Mapped address only. Nothing else has been changed. 

4.1.3.4  A

UX

: 

     Not available at this time.