The luminaires come as a separate master luminaire and a satellite luminaire which must always be installed as a pair. When installing
multiple pairs always ensure that adjacent luminaire are of alternating types. The master luminaire differs from the satellite luminaire in
that it has an LED driver. No more than one satellite luminaire can be used with each master luminaire.
Unit Installation
Align tabs with slots
Run electrical quick connectors through the through-hole
of the two luminaires. Click the male 6-pin connector
of the master luminaire to the female connector of the
satellite luminaire. Ensure the locking feature on the
connectors is firmly engaged.
NOTE:
A maximum of seven master luminaires and seven
satellite luminaires (112 ft.) can be connected on a single
through wiring run.
IMPORTANT:
If the fixtures do not have mating
connectors then one has been installed the wrong way
around. Reinstall the incorrect fixture before proceeding.
Master luminaire
Satellite luminaire
2
Suspend the satellite luminaire adjacent to the master
luminaire according to the installation instructions of
the selected suspension method before attempting to
perform any electrical interconnections.
1
Carefully unpack unit from its packaging. Properly inspect
for defects before installing. Wear work gloves to prevent
dirt and oil from being transferred to the luminaire.
4
6
3
5
Temporarily align two adjacent luminaires by sliding the
tabs into the corresponding slots.
Optional Continuous Run Mounting:
When connecting luminaires in a continuous run, each
master/satellite combination is followed by an additional
pair(s). Ensure electrical connections are secure and
alignment tabs and joiner brackets are securely
fastened between each fixture in the run. Install end
caps (End Cap Kit 69074) to first and last fixtures in runs.
Refer to install instructions in end cap kit (69074) for
proper installation.
Conceal wires and connection between the luminaires by
sliding two joiner covers (provided in Joiner Kit 69073) over
the LED light engine so that they engage with a click.
Use bracket from Joiner Kit (69073) to attach luminaires
by inserting the curved lower tabs into the slots at the
base of the luminaire and rotate the bracket so the
upper tabs slide into the slots at the top of the luminaire.
Install the two screws (provided in Joiner Kit) with a
Phillips head screwdriver.
