background image

IND045-121712

GE Lighting Solutions •  1-888-MY-GE-LED •  www.gelightingsolutions.com

1 - 8 8 8 - 6 9 - 4 3 - 5 3 3

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand and logo are trademarks of the General Electric Company. 

© 2012 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.

Specifications

Input Voltage

120 – 277V

Input Power (complete system)/8 ft.

80W

Input Frequency

50/60Hz

Power Factor

>0.9

THD

<20%

Control

0-10V/DALI

Warranty

5 year limited warranty

Dimensions

1 ft. x 8 ft. x 5 in.

Environmental Operating Temperature Range

 -10°C to +25°C

Environmental Humidity (non-condensing)

20 to 80% Non-condensing, dry location rated

Environmental Storage Temperature Range

-40°C to +60°C

Weight/8 ft.

<35 lbs.     

Environmental Rating

Dry Location

Troubleshooting

Conforms to the following standards:

Symptom

Solution

Luminaires will not turn on

•  Check that the color of the supply side wires match the color of the wires they are connected to.

•  Check that the LED driver connector is fully engaged to the LED light engine connector.

•  Check that the LED light engines are connected at the juction between the two luminaires.

Luminaire on through wiring will 

not turn on

•  Check that the through wiring connector from the previous fixture in the linear row is fully 

engaged to the malfunctioning luminaire.

Joiner bracket will not fit 

between two luminaires in a 

continuous row

• Check that the mating tabs between the luminaires are fully engaged.

• Check that the two luminaires are on the same level with one another and there is no angle 

between them.

Joiner covers will not click 

together

• Check that the joiner covers are a slot and tab pair not two slotted or two tabbed pieces.
• Check that the internal wiring is not in the way of the joiner covers.

Suspension method won’t 

engage with luminaire

• Check that the suspension method is one of the approved types in the installation instruction.

Summary of Contents for IP180 Series

Page 1: ...limentation électrique RISQUES D INCENDIE Respectez tous les codes NEC et codes locaux N utilisez que des fils approuvés par UL pour les entrées sorties de connexion Taille minimum 18 AWG Save These Instructions Use only in the manner intended by the manufacturer If you have any questions contact the manufacturer Prepare Electrical Wiring Electrical Requirements The LED driver must be supplied wit...

Page 2: ...n instructions of the selected suspension method before attempting to perform any electrical interconnections 1 Carefully unpack unit from its packaging Properly inspect for defects before installing Wear work gloves to prevent dirt and oil from being transferred to the luminaire 4 6 3 5 Temporarily align two adjacent luminaires by sliding the tabs into the corresponding slots Optional Continuous ...

Page 3: ...ng control wires through Connect dimming control wires grey and violet for 1 10V or violet and violet white strip for DALI to the similarly colored fixture wire using the provided push in wire nuts 1 3 5 Remove knockout plate from luminaire by loosening the knockout screw and sliding the cover out of luminaire Connect the green ground wire to the green ground wire of the luminaire using the provid...

Page 4: ...following standards Symptom Solution Luminaires will not turn on Check that the color of the supply side wires match the color of the wires they are connected to Check that the LED driver connector is fully engaged to the LED light engine connector Check that the LED light engines are connected at the juction between the two luminaires Luminaire on through wiring will not turn on Check that the th...

Reviews: